What are the environmental requirements for the metal automobile stamping parts fabrication workshop?

With the rapid development of society, people’s living environment must ensure air purification and no pollution. In industrial production, there are certain requirements for the environment of enterprises and production sites. In the metal stamping parts fabrication workshop, both indoor purification and environmental pollution are required. There are certain regulations, let’s take a look at it below;

To set up a dedicated mold repair area, mold repair welding and maintenance must be completed in the dedicated mold repair area. During repair welding and grinding, welding rod smoke and grinding dust should be reduced; a large amount of smoke will be generated during repair welding. Welding smokers should be used to absorb a large amount of welding fumes and reduce pollution;

In the fabrication of metal automobile stamping parts, closed production should be carried out to reduce dust and noise;

The indoor temperature has a certain influence on the sheet metal formability and mold shrinkage rate of metal stamping parts. When the equipment is turned on and running at close to -10 in winter, the self-heating system should complete the heating within 30 minutes;

Fluorescent lamps are added inside the metal stamping parts fabrication workshop to meet the illuminance, the illuminance is generally ≥350lx, and the idling noise during metal stamping parts fabrication should be less than 85dB;

It is necessary to provide employees with safety locks, safety helmets, special earplugs, sleeves, wrist guards, anti-cut gloves, ordinary gloves, aprons, labor protection supplies, etc., to create a metal stamping parts fabrication workshop for safe production;